Laser

There are 8 products.

  • CAD$4.50 In Stock

    This is a general purpose laser receiver which outputs a high signal when it detects a laser pointed towards it.

  • CAD$6.50 In Stock

    The Laser Detector Module outputs a high signal when it detects a laser pointed towards it. This module uses a non-modulated laser receiver which works best indoor with limited light interference.

  • CAD$3.50 In Stock

    This is a low cost red laser pointer. This laser is very similar to laser points which are used in lecture halls. It emits a very narrow beam of light. CAUTION - Avoid viewing of direct laser radiation. Direct exposure to the eyes can cause blindness and other vision problems.    

  • CAD$3.50 In Stock

    This is a low cost red laser pointer. This laser is very similar to laser points which are used in lecture halls. It emits a very narrow beam of light. CAUTION - Avoid viewing of direct laser radiation. Direct exposure to the eyes can cause blindness and other vision problems.  

  • CAD$14.50 In Stock

    Such a little laser emitters are often used in teaching, horizontal measurement and so on. This laser has an adjustable lens which is used to focus the laser beam. CAUTION - Avoid viewing of direct laser radiation. Direct exposure to the eyes can cause blindness and other vision problems.  

  • CAD$24.50 In Stock

    A very powerful 5mW green laser. Fun, but don’t point in anyone’s eyes. These units include a momentary power button and two solder points for permanent on. The trim-pot adjusts the output power. We were able to push the current up to about 400mA where things started getting toasty, and very bright. CAUTION - Avoid viewing of direct laser radiation....

  • CAD$8.60 In Stock

    Use this nice fixed laser mount to attach any of our laser diode modules to your desk, robot, shark, etc. A set-screw holds the laser in place. Has a flat mounting plate with four holes for easy attachment and adjustment. Fits all of our modules. 

  • CAD$16.00 In Stock

    Use this nice adjustable laser mount to attach any of our laser diode modules to your desk, robot, shark, etc. A set-screw holds the laser in place. You can then adjust the tilt. Has a flat mounting plate with two slots for easy attachment and adjustment. 

No products

To be determined Shipping
CAD$0.00 Total

Check out