LED & LCD Display

There are 8 products.

  • $18.95 In Stock

    The LCD Keypad Shield is an easy way to integrate a character display with the Arduino. This is a 16x2 Character LCD with white text on blue backlight.

  • $29.00 In Stock

    This new Adafruit shield makes it easy to use a 16x2 Character LCD. We really like the Blue & White 16x2 LCDs we stock in the shop. Unfortunately, these LCDs do require quite a few digital pins, 6 to control the LCD and then another pin to control the backlight for a total of 7 pins. That's almost half of the pins available on a classic Arduino!

  • $39.95 In Stock

    The screen is 1.77" diagonal, with 160 x 128 pixel resolution. The TFT library interfaces with the screen's controller through SPI when using the TFT library. The screen runs on +5 VDC. The microSD slot is accessible through the SD card library. The LED backlight is dimmable with PWM control. This LCD will fit perfectly with the Arduino Esplora and the...

  • $48.95 In Stock

    This lovely little shield is the best way to add a small, colorful and bright display to any project. We took our popular 1.8" TFT breakout board and remixed it into an Arduino shield complete with microSD card slot and a 5-way joystick navigation switch (with a nice plastic knob)! Since the display uses only 4 pins to communicate and has its own...

  • $18.85 In Stock

    This 2.4” TFT Touch Shield has total resolution of 320 x 240 pixels with individual pixel controls. The TFT screen can display a total of 262,000 different shades at 18 bits with controllable backlight settings.

  • $28.00 In Stock

    This 3.5” TFT LCD Shield has total resolution of 480x320 pixels with individual RGB pixel controls. This display has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. The display can be used in two modes: 8-bit or SPI. For 8-bit mode, you'll need 8 digital data lines and 4 or 5 digital control lines to...

  • $27.50 In Stock

    This 3.0" TFT LCD Mega Shield has a total resolution of 480 x 320 pixels with 262K color. The controller for the LCD module is HX8357C, it supports 16-wires DataBus interface. This shield also includes a 5V-3.3V level shifter and power regulator, SD card socket, as well as SPI FLASH circuit. 

  • $36.00 In Stock

    This WS2812 Pixel Matrix Shield is equipped with 40 WS2812 RGB LEDs arranged in a 5x8 matrix. The shield is powered by the 5V onboard Arduino supply. An external power source of 4 to 6V may be required if you are planning on lighting all the pixel at once at full power

No products

To be determined Shipping
$0.00 Total

Check out