Take a look at our selection of different Character LCDs here! – 16×2, 20×4, I2C and more…
Character LCDs
Showing all 11 results
- Character LCDs
8×2 Tiny Character I2C LCD
This is a breadboard friendly, 2.54mm pitch, I2C controlled 8×2 characters LCD board for 5V microcontroller. It has the pull-up resistors for I2C bus in it. It is the 2.54mm pitch, so you can plug in the breadboard and Arduino. The pin assignment is same as Arduino Uno Analog pins which are used for I2C connection. It has the pull-up resistors for I2C bus in it, so all you have to do is to solder pin header you want to use. However, please be aware that you may want to remove the resistors if you connect other I2C devices on the same bus.
Part Number: LCDMO-046001 - Arduino, Arduino Displays, Character LCDs, Microcontrollers
I2C Controlled LCD Shield
This new Adafruit shield makes it easy to use a 16×2 Character LCD. We really like the Blue & White 16×2 LCDs we stock in the shop. Unfortunately, these LCDs do require quite a few digital pins, 6 to control the LCD and then another pin to control the backlight for a total of 7 pins. That’s almost half of the pins available on a classic Arduino!
Part Number: ARFLD-000772 - Character LCDs, Micro:bit, New Products
micro: bit 16×2 LCD Breakout
This is an add-on for the micro: bit for attaching a 16×2 character LCD. This board comes with a potentiometer for contrast control. There are 2x 3pin JST connector that maps a set of analog and digital port and 2x 4pin JST connector for the I2C & UART.
Part Number: MCBIT-001612 - Character LCDs, Micro:bit
micro: bit 16×2 LCD Breakout
This is an add-on for the micro: bit for attaching a 16×2 character LCD. This board comes with a potentiometer for contrast control. There are 2x 3pin JST connector that maps a set of analog and digital port and 2x 4pin JST connector for the I2C & UART.
Part Number: MCBIT-001602 - 3D Printing, Character LCDs, New Products, Sales
20×4 Character LCD for RepRap Ramps 1.4
This 20×4 LCD board is used with the RAMPS 1.4 3D printer controller. You simply connect the LCD to the RAMPS board. This control unit has a built in SD card reader, rotary encoder as well as a 20×4 LCD display.
Part Number: DDDLC-204914