There are 13 products.

  • $9.00 In Stock

    This battery charger is used to charge two 18650 3.7V lithium ion batteries. The output of this charger is 4.2V @ 1A.

  • $1.80 In Stock

    This is a general purpose 18650 cell battery holder with leads.

  • $3.80 In Stock

    This is a general purpose 18650x2 cell battery holder with a 2.1mm center positive DC barrel plug allowing for easy power conenctions!

  • $11.50 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online.   

  • $11.00 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online.   

  • $13.50 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online. 

  • $19.95 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online. 

  • $22.50 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online. 

  • $29.99 Out of stock
    Out of stock

    The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown and include the necessary protection circuitry. Note: This product is only sold in store and is not available online. 

  • $3.50 In Stock

    This TP4056 lipo charger comes equipped with a micro USB connector for easy connection. The charging current can be adjusted from 100mA to 1000mA by changing the on-board resistor (15K = 100mA, 1.3K = 900mA). 

  • $14.50 In Stock

    If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The LiPo Charger Basic is stripped down of all features and just does one thing well - charge 3.7V LiPo cells at a rate of 500mA. It is designed to charge single-cell Li-Ion or Li-Polymer batteries.

  • $32.95 In Stock

    PowerBoost 1000C is the perfect power supply for your portable project! With a built-in load-sharing battery charger circuit, you'll be able to keep your power-hungry project running even while recharging the battery! This little DC/DC boost converter module can be powered by any 3.7V LiIon/LiPoly battery, and convert the battery output to 5.2V DC for...

  • $14.50 In Stock

    This 5V wireless inductance charger uses the wire coil superposition to active the wireless charging, it can be used in electronic equipments in common use for close wireless charging or power supply. This product consisted of a transmitter and receiver, could serve as a replacement for the Wireless Power Supply with stable 5V output voltage and maximum...

No products

To be determined Shipping
$0.00 Total

Check out