There are 7 products.

  • $10.00 In Stock

    This 3 Channel Manual Servo Controller is an easy way to test any servo motors. You can drive up to 3 independent servo motors with this controller by simply connecting the servo motor along with a power source of 4.8 to 6V into the controller.

  • $19.00 In Stock

    The PCA9685 can help solve the problem of limited digital I/O on your microcontroller. As long as you have an I2C communication function available, you can hook the I2C pin to the PCA9685 board. The PCA9685 board has a built-in clock and PWM drivers, which means you do not required to constantly send signals over from your microcontroller. 

  • $20.50 In Stock

    The TLC5940 is a 16 channel PWM unit with 12 bit duty cycle control (0-4095), 6 bit current limit control (0-63), and a daisy chainable serial interface. This breakout board is a good way to take full advantage of this useful IC. All 16 PWM channels are broken out to standard 0.1" headers, which run alongside convenient voltage and ground rails. Also,...

  • $29.50 In Stock

    The six-channel Micro Maestro raises the performance bar for serial servo controllers with features such as a native USB interface and internal scripting control. Whether you want high-performance servo control (0.25μs resolution with built-in speed and acceleration control) or a general I/O controller (e.g. to interface with a sensor or ESC via your USB...

  • $28.75 In Stock

    You want to make a cool Arduino robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that the Arduino has only a few PWM outputs, and maybe those outputs are conflicting with another shield! What now? You could give up OR you could just...

  • $29.95 In Stock

    The Raspberry Pi is a wonderful little computer, but one thing it isn't very good at is controlling DC Servo Motors - these motors need very specific and repetitive timing pulses to set the position. Instead of asking the Pi Linux kernel to send these signals, pop on this handy HAT! It adds the capability to control 16 Servos with perfect timing. It can...

  • $34.00 In Stock

    This shield allows you to use a computer power supply (or other power source) to use your Arduino to switch high current. With RFP30N06LE MOSFETS, you can easily control a lot of current directly from your Arduino.

No products

To be determined Shipping
$0.00 Total

Check out