Shaft & Bearing

There are 12 products.

  • CAD$2.50 In Stock

    This is a 39mm threaded D4 shaft. 4mm D shafts are often used to mate with different gears, pulleys, shaft couplers, and bearings. Each shaft is made with stainless steel which is extremely durable.

  • CAD$7.50 In Stock

    This linear motion shaft of 4mm in diameter and 80mm in length is suitable for using as shaft, supporting part or using with slide units in linear motion applications. It is made from high-carbon steel and chrome plated for corrosion resistance, case hardened for wear resistance and precision ground for consistent ball bushing radial clearance.

  • CAD$13.00 In Stock

    This is a pack of 4 x 128mm D shaft. 4mm D shafts are often used to mate with different gears, pulleys, shaft couplers, and bearings. Each shaft is made with stainless steel which is extremely durable.

  • CAD$12.50 In Stock

    This linear motion shaft of 8 mm in diameter and 128mm in length is suitable for using as shaft, supporting part or using with slide units in linear motion applications. It is made from high-carbon steel and chrome plated for corrosion resistance, case hardened for wear resistance and precision ground for consistent ball bushing radial clearance.

  • CAD$13.00 In Stock

    This shaft of 8 mm in diameter and 128mm in length is suitable for using as shaft, supporting part, or using with slide units in linear motion applications. It is made from high-carbon steel and chrome plated for corrosion resistance, case hardened for wear resistance. This shaft has M4 threaded holes on both ends. 

  • CAD$46.00 In Stock

    This is a T6 256mm lead screw and brass flange nut set which can be self-locking. The T6 lead screw is perfect for high torque requirements of transmission, such as the aixs for 3D printer. The lead screw also can carry larger load than the threaded rod.

  • CAD$14.00 In Stock

    This 4mm shaft collar is can be used with most 4mm shaft for adding stops on the shaft. This shaft collar uses M3 set screws.

  • CAD$4.90 In Stock

    This 8mm shaft collar can be used with most 8mm shaft for adding stops on the shaft. This shaft collar uses M3 set screws.

  • CAD$13.00 In Stock

    A rod end bearing, also known as a heim joint or rose joint, is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links, tie rods, or anywhere a precision articulating joint is required. A ball swivel with an opening through which a bolt or other attaching hardware may pass is pressed into a circular casing with a...

  • CAD$5.50 In Stock

    These flanged ball bearings has an inner diameter of 1/4" and outer diameter of 1/2". You can use this bearing to run a 1/4" shaft in a 1/2" hole.  

  • CAD$7.50 In Stock

    The Pillow Block bearing is very similar to traditional ball bearings where they are widely used in various of machinery, equipment, conveyors, and many more. The compact design on the bearing unit allows for easy mounting and demounting applications. Documents:Dimension Diagram   

  • CAD$7.90 In Stock

    The Pillow Block bearing is very similar to traditional ball bearings where they are widely used in various of machinery, equipment, conveyors, and many more. The compact design on the bearing unit allows for easy mounting and demounting applications. Documents:Dimension Diagram   

No products

To be determined Shipping
CAD$0.00 Total

Check out