There are 25 products.
- $5.25 In Stock
These small steppers are a great way to get things moving, especially when positioning and repeatability is a concern. Note: This is a Unipolar stepper, meaning that if you are going to drive it with a bipolar stepper driver, you will only use 4 of the 6 leads.
- $29.00 In Stock
This small NEMA 8-size hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 600 mA at 3.9 V, allowing for a holding torque of 180 g-cm (2.5 oz-in). With a weight of 60 g, this is one of the smallest stepper motors we carry.
- $41.80 In Stock
These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear motion where precision and repeatability are important.
- $6.95 In Stock
This black anodized aluminum bracket lets you securely mount typical NEMA 17-size stepper motors to your project. The bracket features several slots and holes for a wide variety of mounting solutions, and four screws are included for securing the motor to the bracket.
- $7.80 In Stock
You have a stepper motor, but you need to attach it to your CNC project, eh? Not so easy if you don't have a stepper motor mount just like this fine one one here! This mount will fit any NEMA-23 motor with four screws. There's two Made of steel with welded 90-degree support triangles, its got a solid construction.
- $13.00 In Stock
The EasyDriver is a simple to use stepper motor driver that can driver up to about 750mA per phase of a bi-polar stepper motor. EasyDriver requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire...
- $28.00 In Stock
Each Big Easy Driver can drive up to a max of 2A per phase of a bi-polar stepper motor. It is a chopper microstepping driver which defaults to 16 step microstepping mode. It can take a maximum motor drive voltage of around 30V, and includes on-board 5V/3.3V regulation, so only one supply is necessary. Although this board should be able to run most systems...
- $14.00 In Stock
The A4988 is a complete microstepping motor driver with a built-in translator for easy operation. The A4988 has 5 modes including full, half, 1/4, 1/8 and 1/16 steps. The driver is able to operate any bipolar stepper motor with an output up to 35V 2A. Note: This is an A4988 stepper motor driver and is not a product from Pololu Robotics & Electronics.
- $14.25 In Stock
Black Edition A4988 stepper motor driver carrier is a higher-performance drop-in replacement for the original A4988 stepper motor driver carrier. It features a four-layer PCB for better thermal performance, allowing the A4988 microstepping bipolar stepper motor driver to deliver approximately 20% more current than our two-layer (green) version. Like our...