18″ Servo Switch Harness
UMTRS-002171This 18″ (45 cm) harness has an inline on/off switch, with a 0.1″ 3-pin female connector on one end and both a male and a female connector on the other. This 3-wire harness can be used to add a toggle switch between any two devices that can be connected with JR style servo connectors. One side of the switch has a lead with a female connector, while the other side has two leads, one male and one female.
$5.90 |
Customers Also Viewed
- Motors, Gear Motors
FDS5672 Motor Driver- 9A
This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. The little 1.3 0.8-inch board supports a wide 5.5 to 50 V voltage range and is efficient enough to deliver a continuous 9 A without a heat sink.
Part Number: PROMR-008756 - Arduino, Arduino Motor Drivers, Microcontrollers, Motors, Gear Motors
VNH5019 Dual Motor Shield – 12A
Arduino, Arduino Motor Drivers, Microcontrollers, Motors, Gear MotorsVNH5019 Dual Motor Shield – 12A
This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its dual robust VNH5019 motor drivers operate from 5.5 to 24 V and can deliver a continuous 12 A (30 A peak) per motor, or a continuous 24 A (60 A peak) to a single motor connected to both channels. These great drivers also offer current-sense feedback and accept ultrasonic PWM frequencies for quieter operation. The Arduino pin mappings can all be customized if the defaults are not convenient, and the motor driver control lines are broken out along the left side of the shield for general-purpose use without an Arduino.
Part Number: ARDMD-002507 - Motors, Gear Motors
150: 1 15.5D Micro Metal Gear Motor (6V 200RPM)
This gearmotor is a miniature (0.94″ x 0.39″ x 0.47″), high-power brushed DC motor with 150.58: 1 metal gearbox, similar to Sanyo s popular 12 mm gearmotors. These units have a 0.365″-long, 3 mm-diameter D-shaped output shaft.
Part Number: MOTOR-110997
