ATtiny26 – 8 Bit Microcontroller with 2KB Flash
ICUPC-772616$3.60 |
Customers Also Viewed
- Arduino, Arduino SD Storage, Arduino Wi-Fi, Microcontrollers, Wireless & IoT, Wi-Fi
RN171 Long Distance WiFi Shield
Arduino, Arduino SD Storage, Arduino Wi-Fi, Microcontrollers, Wireless & IoT, Wi-FiRN171 Long Distance WiFi Shield
This RN171 WiFi Shield is a long range WiFi solution for the Arduino. You can start controlling application through the internet with a few simple instructions. The RN171 is also a complete and standalone TCP/IP wireless network module.
Part Number: ARDWE-001701 - Arduino, Arduino SD Storage, Microcontrollers
CAN-BUS Shield
The CAN-BUS Shield provides your Arduino or Redboard with CAN-BUS capabilities and allows you to hack your vehicle. This shield allows you to poll the ECU for information including coolant temperature, throttle position, vehicle speed, and engine rpms. You can also store this data or output it to a screen to make an in-dash project.
Part Number: ARDCN-013262 - Arduino, Arduino Relays, Microcontrollers, Switches & Relays, DC Relays
Relay Shield
This Relay Shield from Evil Mad Scientist is a simple Arduino add-on that gives your Arduino the ability to control a single electromechanical relay for switching loads of up to 24VDC or 40VAC. Each Relay Shield comes equipped with a single pole – double throw (SPDT) sealed relay which can handle a current load of up to 5A. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC (Normally Closed) contact to ground and closing the NO (Normally Open) contact. Use them to switch high voltage/high current devices. As this is a shield, it is powered straight from the 5V power supplied by your Arduino, simply slide it into your Arduino or shield-compatible board (like the RedBoard) and you will be good to go!
Part Number: ARDRL-012093 - Arduino, Microcontrollers
Arduino Uno Rev3
The Arduino Uno is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.
Part Number: ARDDU-031366
