The BMP085 a high-accuracy barometric sensor chip which detects barometric pressure and temperature. It can widely measure pressure ranging from 300hPa to 1100hPa, AKA +9000m to -500m above sea level, with a super high accuracy of 0.03hPa(0.25m) in ultra-high resolution mode. This barometric sensor is compatible with both 3.3V and 5V logic.
$17.00 |
Features:
Documents:
This carrier board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins ground, power and analog voltage output that are broken out with a 0.1″ spacing, making the board compatible with 0.1″ headers and standard breadboards and perfboards. This board has two mounting holes and provides convenient pads for mounting the gas sensor s required sensitivity-setting resistor.
This breakout board is the simplest way to create a project with a single “momentary” capacitive touch sensor. No microcontroller is required here – just power with 1.8 to 5.5VDC and touch the pad to activate the sensor. When a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED lights up and the output pin goes high. You can also solder a wire to the middle pad and create your own capacitive pad if the built-in one isn’t suited to your project.
This is the T5403 breakout board, a fully calibrated barometric pressure sensor with an I2C interface. The T5403 sensor measures the absolute pressure of the air around. This pressure varies with both the weather and altitude. Depending on how you interpret the data, you can monitor changes in the weather, measure altitude, or any other tasks that require an accurate pressure reading.
