This motor driver kit and its corresponding Python library make it easy to control a pair of bidirectional, brushed DC motors with a Raspberry Pi. The expansion board features Texas Instruments DRV8835 dual H-bridge motor driver IC, which allows it to operate from 1.5 V to 11 V and makes it particularly well suited for driving small, low-voltage motors. The board can deliver a continuous 1.2 A per channel and tolerate peak currents up to 1.5 A per channel for a few seconds, and the channels can be optionally configured to run in parallel to deliver twice the current to a single motor. The board ships fully populated with its SMD components, including the DRV8835 driver and a FET for reverse battery protection; header pins for interfacing with a Raspberry Pi and terminal blocks for connecting motors and power are included but are not soldered in (see theAssembly with included hardware section below).

Features:

• Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor
• Motor supply voltage: 1.5 V to 11 V
• Logic supply voltage 2 V to 7 V
• Output current: 1.2 A continuous (1.5 A peak) per motor
• Motor outputs can be paralleled to deliver 2.4 A continuous (3 A peak) to a single motor
• PWM operation up to 250 kHz (ultrasonic frequencies allow for quieter motor operation)
• Two possible interface modes: PHASE/ENABLE (default one pin for direction, another for speed) or IN/IN (outputs mostly mirror inputs)
• Board can optionally power the Raspberry Pi base directly through add-on regulator (not included)
• Python library makes it easy to get started using this board as a motor driver expansion board
• GPIO pin mappings can be customized if the default mappings are not convenient
• Reverse-voltage protection on motor power supply
• Under-voltage lockout and protection against over-current and over-temperature

Documents:

• DRV8835 Datasheet
• Python Library