MQ Gas Sensor Breakout Board
SPEDE-000079This carrier board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins ground, power and analog voltage output that are broken out with a 0.1″ spacing, making the board compatible with 0.1″ headers and standard breadboards and perfboards. This board has two mounting holes and provides convenient pads for mounting the gas sensor s required sensitivity-setting resistor.
$2.10 |
Customers Also Viewed
- Sensors, Temperature Sensors, Water Sensors
DHT22 Humidity and Temperature Sensor
The DHT22 (also known by RHT-03) is a low cost humidity and temperature sensor with a single wire digital interface. The sensor is calibrated and doesn t require extra components so you can get right to measuring relative humidity and temperature.
Part Number: SPEDE-010167 - Sensors, Touch Sensors
AT42QT1010 Capacitive Touch Sensor (Momentary)
This breakout board is the simplest way to create a project with a single “momentary” capacitive touch sensor. No microcontroller is required here – just power with 1.8 to 5.5VDC and touch the pad to activate the sensor. When a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED lights up and the output pin goes high. You can also solder a wire to the middle pad and create your own capacitive pad if the built-in one isn’t suited to your project.
Part Number: PROTS-001374 - Sales, Sensors, Temperature Sensors
Type K Thermocouple
Thermocouples are best used for measuring temperatures that can go above 100 Degree C. This is a bare wires bead-probe which can measure air or surface temperatures. Most inexpensive thermocouples have a vinyl covering which can melt at around 200 Degree C, this one uses a fiberglass braid so it can be used in high temperature measurements such as heaters and ovens. There’s a small piece of heat shrink on the end to keep the fiberglass from fraying. If you’re using at >250 Degree C temperatures, simply remove it with a small blade.
Part Number: SPEDE-000270 - Sensors, Gas Sensors
MQ-4 Methane Gas Sensor
This semiconductor gas sensor detects the presence of methane (CNG) gas at concentrations from 300 ppm to 10,000 ppm, a range suitable for detecting gas leaks. The sensor s simple analog voltage interface requires only one analog input pin from your microcontroller.
Part Number: SPEDE-000050
