This black anodized aluminum bracket lets you securely mount typical NEMA 17-size stepper motors to your project. The bracket features several slots and holes for a wide variety of mounting solutions, and four screws are included for securing the motor to the bracket.
You can read this wire with an analog input such as those on an Arduino, to get the servo’s position. That information can be used in robotics to improve stability or even allow ‘recording’ of servo motion. The dimensions of this analog feedback motor are 11.57 x 22.75 x 29.45mm. The operating voltage for this motor ranges between 4.8 to 6V. Servo horns and associated hardware are also included in the package.
This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. The little 1.3 0.8-inch board supports a wide 5.5 to 50 V voltage range and is efficient enough to deliver a continuous 9 A without a heat sink.
This 2.05″ ?1.45″ ?1.45″gearmotor is a powerful brushed DC motor with metal gearbox intended for operation at 12 V. These units have a 0.61″-long, 6 mm-diameter D-shaped output shaft.
This small NEMA 8-size hybrid bipolar stepping motor has a 1.8 Degree step angle (200 steps/revolution). Each phase draws 600 mA at 3.9 V, allowing for a holding torque of 180 g-cm (2.5 oz-in). With a weight of 60 g, this is one of the smallest stepper motors we carry.
This motor driver shield can drive up to 4 DC motor with 2 servo motors or 2 stepper motors with 2 servo motors. This motor driver shield uses 2x L293D motor controller chip with a 74HC595 shift register for all of its functions.