PIC18F2620 – 16 Bit Enhanced Flash-Based USB Microcontroller with 10 Bit A/D Converter
ICUPC-182620The PIC18F2620 is a high performance, enchanced FLASH USB microcontroller with nanoWatt technology.
Documents:
$11.50 |
Customers Also Viewed
- Arduino, Microcontrollers
Wixel Shield
Unleash your Arduino! This shield allows you to interface Wixel wireless modules to your Arduino (and other compatible products), enabling simple wireless programming, debugging, and control using standard Arduino software. Wixel developers can also use this item as a Wixel prototyping board.
Part Number: ARDWX-002500 - Arduino, Arduino Bluetooth, Microcontrollers, Wireless & IoT, Bluetooth
HC-05 Bluetooth Shield
The HC-05 Bluetooth Shield is an easy way to connect the Arduino to any Bluetooth device. The HC-05 Bluetooth Module is a v2.0+EDR (Enhanced Data Rate) Bluetooth which uses a2.4GHz radio transceiver with 3Mbps modulation.
Part Number: ARDBE-001108 - Arduino, Arduino Prototyping, Microcontrollers, Double Sided Perf Boards
Protoshield for Arduino Mega
Arduino, Arduino Prototyping, Microcontrollers, Double Sided Perf BoardsProtoshield for Arduino Mega
This protoshield is a simple and clean prototyping shield for the Arduino Mega, in which you can directly solder and bulit your circuit and project right on top of your arduino mega.
Part Number: ARDPC-256000 - Arduino, Arduino Relays, Microcontrollers, Switches & Relays, DC Relays
Relay Shield
This Relay Shield from Evil Mad Scientist is a simple Arduino add-on that gives your Arduino the ability to control a single electromechanical relay for switching loads of up to 24VDC or 40VAC. Each Relay Shield comes equipped with a single pole – double throw (SPDT) sealed relay which can handle a current load of up to 5A. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC (Normally Closed) contact to ground and closing the NO (Normally Open) contact. Use them to switch high voltage/high current devices. As this is a shield, it is powered straight from the 5V power supplied by your Arduino, simply slide it into your Arduino or shield-compatible board (like the RedBoard) and you will be good to go!
Part Number: ARDRL-012093
