This RN171 WiFi Shield is a long range WiFi solution for the Arduino. You can start controlling application through the internet with a few simple instructions. The RN171 is also a complete and standalone TCP/IP wireless network module.
$69.95 |
This is a set of 40 pin splittable jumper wires. Each jumper wire has a length of 200mm (8 inches) and comes with both male and female ends. This kind of flexible jumper wire is perfect for breadboard use as it fits perfectly in the breadboard.
The Arduino Uno is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.
This is a set of 40 pin splittable jumper wires. Each jumper wire has a length of 200mm (8 inches) and comes with both female ends. This kind of flexible jumper wire is perfect for breadboard use as it fits perfectly in the breadboard.
This board is based on the ATmega328 microcontroller. This board shares the same form factor and functionally as the Arduino Uno Rev3. Some key features of this board includes 14 digital I/O of which 6 has PWM output, 6 analog input, 16MHz clock speed, and USB interface.
Note: This is an ATmega328 microcontroller board and is not a product from Arduino.
This is a set of 40 pin splittable jumper wires. Each jumper wire has a length of 200mm (8 inches) and comes with both male ends. This kind of flexible jumper wire is perfect for breadboard use as it fits perfectly in the breadboard.
Features:
Documents:
This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its dual robust VNH5019 motor drivers operate from 5.5 to 24 V and can deliver a continuous 12 A (30 A peak) per motor, or a continuous 24 A (60 A peak) to a single motor connected to both channels. These great drivers also offer current-sense feedback and accept ultrasonic PWM frequencies for quieter operation. The Arduino pin mappings can all be customized if the defaults are not convenient, and the motor driver control lines are broken out along the left side of the shield for general-purpose use without an Arduino.
This shield allows you to use a computer power supply (or other power source) to use your Arduino to switch high current. With RFP30N06LE MOSFETS, you can easily control a lot of current directly from your Arduino.
This is a 5V Arduino running the 16MHz bootloader. Arduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. The Arduino Pro series is meant for users that understand the limitations of system voltage (5V), lack of connectors, and USB off board.
The CAN-BUS Shield provides your Arduino or Redboard with CAN-BUS capabilities and allows you to hack your vehicle. This shield allows you to poll the ECU for information including coolant temperature, throttle position, vehicle speed, and engine rpms. You can also store this data or output it to a screen to make an in-dash project.
The Arduino Due is a microcontroller board based on the Atmel SAM3X8E ARM Cortex-M3 CPU. It is the first Arduino board based on a 32-bit ARM core microcontroller. It has 54 digital input/output pins (of which 12 can be used as PWM outputs), 12 analog inputs, 4 UARTs (hardware serial ports), a 84MHz clock, an USB OTG capable connection, 2 DAC (digital to analog), 2 TWI, a power jack, an SPI header, a JTAG header, a reset button and an erase button.
