Wireless Communication

W5100 Ethernet Shield

ARDFD-051000


The W5100 Ethernet Shield connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino board, connect it to your network with an RJ45 cable and follow a few simple instructions to start controlling your world through the internet.

More details

CAD$28.50

- +

 
More info

The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.

Arduino communicates with both the W5100 and SD card using the SPI bus (through the ICSP header). This is on digital pins 11, 12, and 13 on the Arduino Uno and pin 10 is used to select the W5100 while pin 4 is used for the SD card. These pins cannot be used for general I/O. 

Features:

  • W5100 Ethernet controller with 16K internal buffer
  • 10 / 100MB connection speed
  • microSD socket for storage
  • RJ45 jack
  • SPI Interface

Documents:

Write a Review

W5100 Ethernet Shield

The W5100 Ethernet Shield connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino board, connect it to your network with an RJ45 cable and follow a few simple instructions to start controlling your world through the internet.

15 other products in the same category:

No products

To be determined Shipping
CAD$0.00 Total

Check out